Main features:
- 110/230 VAC 50/60 Hz power supply
- Charges/discharges coil magnets to calibrate correct sensitivity
- General working test
- Applicable for all hydraulic actuators from Regulateurs Europa
More information
HEINZMANN
Engine & Turbine Management
HEINZMANN Electric Drives
Robust electric motors
REGULATEURS EUROPA
Control & Monitoring
HEINZMANN China
Control & Actuation
HEINZMANN Automation
Marine Automation
HEINZMANN Australia
Steam Turbine Control
CPK Automotive
Emission Control
Giro Engineering
Diesel Engine Components
HEINZMANN IFT GmbH
Oil Mist Separators and Blow-by Filter Technology
HEINZMANN Regulateurs Europa
Advanced systems for engines, turbines, and tomorrow
AK 8
Actuator Charger
Actuator Calibration Unit
Test Stand AK8
For testing of governors and actuators of all major brands. The basis of the test stand is a sophisticated PLC. The PLC controls a frequency converter which in turn drives a 5.5 kW electric motor. The governor or actuator is direct driven by the electric motor. When in closed loop mode, the test stand simulates a diesel engine. This means that the "load" on the engine is simulated by the test stand. If the set speed of the governor is altered the governor output will change momentary to increase or decrease the amount of "fuel" applied. This will cause the drive speed to change accordingly. Also if the simulated load on the test stand is changed the output position of the governor will change to maintain the set speed.
Main features:
- All-electric. 5.5 kW drive
- Includes oil supply to fill the governor under test
- Governor oil may be circulated and pre-heated
- Operated from a 15" colour touch screen HMI
- Includes 4 ... 20 mA speed setting driver
- Operates in open and closed loop mode
More information
Actuator Charger / Tester
For calibration of all RE actuators. The magnets in all RE actuators are accurately calibrated at the factory guaranteeing the actuator performs in the precise manner the design intended. At overhaul of the actuator and/or strip down of the actuator assembly it is essential to re-calibrate the magnet to maintain the accurate operation of the unit. The RE actuator charger/tester is designed specifically to do this task and is available in either 110 VAC or 230 VAC 50/60 Hz power supply format.
Main features:
- 110/230 VAC 50/60 Hz power supply
- Charges/discharges coil magnets to calibrate correct sensitivity
- General working test
- Applicable for all hydraulic actuators from Regulateurs Europa
More information
Actuator Calibration Unit
The actuator calibration unit ACU is a tool for maintenance and repair of HEINZMANN actuators. It is designed to perform a general working test of actuators and to calibrate actuators analogue feedback.
Main features:
- Analogue feedback calibration
- General working test
- Cable harness included
- Applicable for:
StG 6, StG 10,
StG 16 to StG 40,
StG 64 and StG 90 with or without brake,
StG 180 with or without brake
StG 2010, StG 2040 and StG 2080 with standard Cannon plugs
More information